cancel
Showing results for 
Search instead for 
Did you mean: 
Security Alert Log4j Security Vulnerability. Click here to know more.
cancel
Showing results for 
Search instead for 
Did you mean: 

Config setting drawing_name_sameas_model_name not working

kdirth
18-Opal

Config setting drawing_name_sameas_model_name not working

Has anyone tried the config setting drawing_name_sameas_model_name?  The documentation I found for it says "yes" will auto select the check box for Use drawing model file name.

 

I found it today and set it to yes.  When I tried making a new drawing for a part, the checkbox on the New window was not checked for me.  Using 7.7.5.0

kdirth_0-1638479869229.png

 


There is always more to learn in Creo.
1 ACCEPTED SOLUTION

Accepted Solutions

I removed the PTC folder, no Creo subfolder in it as mentioned in CS35023, from C:\Users\Kdirth\AppData\Local and restarted Creo.  It is now working.


There is always more to learn in Creo.

View solution in original post

3 REPLIES 3
TomU
23-Emerald II
(To:kdirth)

Yes, it's working for me in 7.0.5.0 and later.

 

See if this article helps:  https://www.ptc.com/en/support/article/CS350233

kdirth
18-Opal
(To:TomU)

I closed Creo and deleted the Creo folder at C:\Users\Kdirth\AppData\Roaming\PTC, as suggested in the article, then restarted Creo.  The box remains unchecked when I create a drawing for a new part.


There is always more to learn in Creo.

I removed the PTC folder, no Creo subfolder in it as mentioned in CS35023, from C:\Users\Kdirth\AppData\Local and restarted Creo.  It is now working.


There is always more to learn in Creo.
Announcements