Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
I have some existing parts and assemblies that
I want to convert from Y-Up coordinate system to Z-Up using a Mapkey.
Any suggestions?
Seems duplicate of https://community.ptc.com/t5/Part-Modeling/Mapkey-Select-a-Plane-without-using-the-Mouse/td-p/645455/jump-to/first-unread-message
Yeah... I didn't know if the title of my previous post was going to be clear enough...
Thanks for adding the link... that should work.
