cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you know you can set a signature that will be added to all your posts? Set it here! X

Cosmetic Sketch Hatching

ToddMalenke
1-Visitor

Cosmetic Sketch Hatching

I am running WF4.0 M80..



Has anyone run into an issue of creating a Cosmetic Sketch ( with Hatching )
on a Part, BUT the hatch will not show up on the drawing?... the boundary of
the sketch will show and the hatching temporarily highlights as you pass
your cursor over it, but the hatch will not display or print.



In this case, I am using this to simply highlight an area of a part to
depict a special paint requirement. But have used this for special GDT
requirements as well ( older pro/E version ).



My work-around was to use draft entity hatch that area, but it is bugging me
to no end, it SHOULD work with a cosmetic sketch.



- - - - - - - - - - - - - - - - - - - - - - - - - - -

Todd Malenke - Design Engineering



Machining & Welding by Olsen, Inc.

250 Olsen Blvd, POBox 970, Cokato, MN 55321

952-516-7655 - Direct

320-286-2187 - Phone

320-286-2962 - Fax




This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1
Bari
14-Alexandrite
(To:ToddMalenke)

It's a problem with M080 datecode. Just update to datecode M090 or above.
Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags