Create sketched datum point

[DRFaust]

In WildFire 4.0 I could create a "Sketched datum point" but now I can not figure out how to do this in Creo 2.0. Is it possible? I have attached a screen shot of the tool in WildFire 4.0.

Thanks..

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[StephenW]

Create a sketch feature and add a geometry point. When you finish the sketch, it creates the datum point.

[DavorGranic · Accepted solution]

You can just create sketch and in it you have option to put point. When you complete sketch you will see point.

[DRFaust]

Yup that is it.. I had my "Datum group" turned off and was picking the point tool in the "Sketching group" in the Sketcher Ribbon by mistake.

Thanks...