Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
How do I set all sketch user dimensions to automatically be Locked? I could do this in Wildfire but can't figure out how in Creo, I am having to right mouse button each dimension to lock.
JD Mather
Certified SolidWorks Professional
Autodesk Inventor Certified Expert
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
On 01/20/12 15:33, JD Mather wrote: > How do I set all sketch user dimensions to automatically be Locked? > I could do this in Wildfire but can't figure out how in Creo, I am having to right mouse button each > dimension to lock.
Have a look at the following config options: sketcher_dimension_autolock sketcher_lock_modified_dims
-- ------------------------------------------------------------------------ Randy Jones Systems Administrator Great Plains Mfg., Inc. 1525 E North St PO Box 5060 Salina, KS USA 67401 email: - Phone: 785-823-3276 Fax: 785-667-2695 ------------------------------------------------------------------------
