Creo Parametric M250 wont launch after premature exit

[VMcD]

I am using Creo Parametric 2.0 M250, it was working fine for months. Does anyone have any other tricks I didn't try below?

After Creo prematurely exit, parametric.exe no longer launches. This happened before and after a reinstallation. I tried these options

Check AppData
Check C:\ProgramData\PTC
Check ipconfig /all
Article on VPN issues: Creo Won't Launch - PTC Community
Disabled this Network Adapter: NCP Secure Client Virtual NDIS6.20 Adapter

[MartinHanak]

---

@VMcD wrote:

I am using Creo Parametric 2.0 M250, it was working fine for months. Does anyone have any other tricks I didn't try below?

After Creo prematurely exit, parametric.exe no longer launches. This happened before and after a reinstallation. I tried these options

Check AppData
Check C:\ProgramData\PTC
Check ipconfig /all
Article on VPN issues: Creo Won't Launch - PTC Community
Disabled this Network Adapter: NCP Secure Client Virtual NDIS6.20 Adapter

---

Hi,

try to look for an error in Event Viewer.