Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X
I am using Creo Parametric 2.0 M250, it was working fine for months. Does anyone have any other tricks I didn't try below?
After Creo prematurely exit, parametric.exe no longer launches. This happened before and after a reinstallation. I tried these options
Check AppData
Check C:\ProgramData\PTC
Check ipconfig /all
Article on VPN issues: Creo Won't Launch - PTC Community
Disabled this Network Adapter: NCP Secure Client Virtual NDIS6.20 Adapter
@VMcD wrote:
I am using Creo Parametric 2.0 M250, it was working fine for months. Does anyone have any other tricks I didn't try below?
After Creo prematurely exit, parametric.exe no longer launches. This happened before and after a reinstallation. I tried these options
Check AppData
Check C:\ProgramData\PTC
Check ipconfig /all
Article on VPN issues: Creo Won't Launch - PTC Community
Disabled this Network Adapter: NCP Secure Client Virtual NDIS6.20 Adapter
Hi,
try to look for an error in Event Viewer.