cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Datum Point Table with Radius

Ink
4-Participant
4-Participant

Datum Point Table with Radius

Is it possible to populate the radius along with X, Y, Z coordinates when creating a tube from the Pipe command in a 2D drawing using Hole Tables?  Also, I've included a table created in Catia or NX (see attached: piping table) and was hoping someone could point me in the right direction and let me know if Creo is capable of producing something similar.  I am using Creo 7.

0 REPLIES 0
Top Tags