cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Datum point in a sketch, and hole table

Dom_BOUCHARDY
9-Granite

Datum point in a sketch, and hole table

Hi all,

 

I ask the community before PTC...

We use CREO 7.0.2.0.


We use datum point in a sketch, to figure location of several concrete mass.
We put an hole table, edit the point tag according the CS21713 tips

 

But in the drawing, we would like to show them using a leader note for making a visual link between the hole table and the view.

How can we retrieve the point name in the leader note?
I try the &Name but it doesn't work.

Second question:
In the table hole, can we use relation, like in repeat region?

We would like to use a relation in order to simplify the name of each point.
For example:
Point name : 001_SE08_114
Point name simplified : SE08

 

Regards

1 ACCEPTED SOLUTION

Accepted Solutions

Hi,

in https://www.ptc.com/en/support/article/CS133915 document you will find system parameters applicable in drawing. Unfortunately parameter representing feature name does not exist. You can create leader note containing &mypar:att_feat string if you add parameter mypar to specific feature.


Martin Hanák

View solution in original post

2 REPLIES 2

Hi,

in https://www.ptc.com/en/support/article/CS133915 document you will find system parameters applicable in drawing. Unfortunately parameter representing feature name does not exist. You can create leader note containing &mypar:att_feat string if you add parameter mypar to specific feature.


Martin Hanák

Thanks Martin.

It's clear.

Top Tags