Datum targets on multiple views and multiple sheets

[ptc-1773724]

Is there a way to show datum targets spanning multiple views and sheets of a drawing? I'm able to show the annotations on sheet one but the "Show Annotation" field is blank on the sheet two.

What am I doing wrong?

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[TomD.inPDX]

Datums should allow multiple instances in valid orientations. Dimensions only show in one location.

[ptc-1773724]

I'm able to show datums without any problem. It's the datum targets that only show up on one page.

[TomD.inPDX]

Now that would be silly, woundn't it. You might submit this as a support case.