cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Stay updated on what is happening on the PTC Community by subscribing to PTC Community Announcements. X

Design for Railway carriage

ptc-5669665
1-Newbie

Design for Railway carriage

Hi everyone,

I was just designing a railway passenger bogie.

What will be the best method to draw in Creo 2.0 parametric

I was thinking of beam elements are to be used o/ r extrusion of part.

Attached is sample picture.

Will expert guide how to draw assembly so that it can run with loading analysis.

Thanks,

Dhiraj


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
4 REPLIES 4

The best way would be to ask that question in the Creo subspace of this forum and not here in the Mathcad section 😉

As Werner & Vladimir both suggested, I've moved this discussion into our Community.

I think you'll need to be a little clearer about what you want to do.

Firstly, are you designing a bogie or the carriage body? (From your sketch, I think the body.)

Secondly, when you say "design" are you actually looking to do a stress analysis?

Top Tags