Display BOM position of a part in drawing as note

[Jnithini]

 I am using Creo 7.0. I have an assembly. I want to show the BOM position of a particular part in the drawing as a note. Can we extract that BOM position as a parameter in the drawing. So that whenever the position of that part change, it will be refreshed in the drawing too.

[MartinHanak · Accepted solution]

Hi,

• you cannot put BOM position into note
• BOM positions are generated inside repeat region table
• BOM positions can be displayed in BOM Balloons, only

[Jnithini]

Thanks for the response

[StephenW]

No, unfortunately it is not possible to use repeat region parameters outside of the table or balloons

[Jnithini]

Thanks for your response