Display Windchill generated "Number" parameter on a Creo Drawing.

[ptc-5072722]

We are currently using Windchill 10.1 and Creo Elements Pro 5.0. I am currently creating a drawing template and need to display the Windchill "Number" parameter on a drawing. However, I am not sure of what call out to use.

I was reading around and if it is right, do is it &PTC_WM_PART_NUMBER? But it says on one of the thread (http://communities.ptc.com/thread/36053) that this parameter is ommited from PROE files.

Can you please advise if that is possible and how to?

Thanks,

Mark

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[magnus.salomons]

You could use a system parameter &model_name assuming that your filename is same as number in WC. See available system parameters https://www.ptc.com/appserver/cs/view/solution.jsp?n=CS133915&posno=7&q=&model_name&nav=ptcproductgroups||creo||Product+Group||creo^^ptcmodule||

[ClintWalton]

Mark,

I'm not a Workgroup Manager expert but I found the following document that may help:

https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS18803&source=tssearch