Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
Good Afternoon everyone! I have a few drawings that take quite a while (20 - 40 minutes) to open if you open the drawing without opening the assembly first. If I erase not displayed, I can open the Master Rep of the assembly in 2-3 minutes. Once the assembly is open the drawing will open in 3 - 5 minutes no problem.
These are multi-sheet drawings & can be up to 11 pages of sections of the same assembly. We use a simplified rep on the drawing to exclude quite a bit of detail and the operator in charge of one of these drawings is very thorough about his simplified reps.
The big concern is Why does it take so long to open these drawings - without the assembly first? There are times when these drawings will also unexpectedly slow down and drag out each mouse click. Not sure if these issues are related but they can be pretty painful when everybody is screaming for drawings.
We are running WF4 M092 - I can't change this.. don't bother 😞 within Windchill 9.0 M030 - yep, you guessed it, I can't change this either....
thanks for your help!
Martin T. Brown Design Specialist Facilities, Science & Technology Merrick & Company 1099 Commerce Park Drive Oak Ridge, Tennessee 37830 Direct: 865-241-4642 www.merrick.com This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
