ECAD out

[wfalco]

On wf5.....

I've been out of the board game for a while. But used to do a lot.

Can someone tell me key config options I need to set to export to an
emn?

Currently getting warnings that components are being ignored.

Ecad folks saying only board is coming across.

Using "board station" option.

This is going to MentorGraphics (I can get more details if needed).

Thanks,

Wayne
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[jjakubos]

Test.

Regards,

Jim Jakubos
Project Engineer
Rexair, LLC
-

231-876-3934



This email and any attachments are confidential and may be legally
privileged. If you are not the intended recipients, please notify
the author by replying to this email message, and then delete all
copies of the email on the system. If you are not the intended
recipient, you must not disclose, distribute, copy, print or use
this email in any manner.

Email messages and attachments may contain viruses. Although we
take precautions to check for viruses, we make no assurances about
the absence of viruses. We accept no liability and suggest that
you carry out your own virus checks.

[bokm9606]

I always use version 2.0 for ecad export.

Be sure your component export have an insertion CSYS (ecad_default)

[wfalco]

Thank you's to all who submitted info on this. Will take some time to go
thru it all.