Explode View help needed WF3

[ptc-267878]

I adjusted explode view in Assembly by using "View -> Explode -> Edit Position".

I go to Drawing mode -> View States -> Explode view, but I don't see an option for me to get by adjusted explode view. just the default explode view. what step am i missing?

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[ptc-267878]

where is the "save" explode view option?

[ptc-267878]

answer: view manager -> explode tab

[BobSchwerdlin]

While you in the exploded state creation, click on the "list" button and then a list of exploded states will be shown. RMB in that window and select, SAVE, then save the top level assembly. You actually need to save twice ! Very intuitive, huh? There is absolutely no mention of this anywhere.

Best of luck,

Bob