Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily.
X
There used to be an option that would allow you to use the sub-assembly explode state in a higher level assembly, this option appears to be removed in Creo/Wildfire 5. Does anyone know where I can find this option?
Thank you
Ryan Crisp | Senior Mechanical Engineer
Priority Designs 501 Morrison Rd. Columbus, OH 43230 (614) 337-9979 www.prioritydesigns.com This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
