I'm trying to edit some location of some bolt holes in a model that was done by an engineer who knows alot more about Creo than I do.
Below is part of what defines it.
DRILL_DIAMETER = (FLOOR(((diameter*scale)*100)+.5))/100
ELSE
DRILL_DIAMETER = (FLOOR(((diameter*scale)*10)+.5))/10
ENDIF
first_loc_dist = (FLOOR((( (((d34/2)+(cbore_diameter/2)+.09)*sin(45)) )*1000)+.5))/1000
second_loc_dist = first_loc_dist
My question is how do I find out information about the "FLOOR" above. I tried selecting it and clicking on driven by and driving but it says invalid symbol name and I can't find it in any parameter.
How do I figure out where this FLOOR is defined?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
