How do I save the CG?

[NEALROSENBLUM]

All,

I cannot figure out how to save the CG. Iselect ANALYSIS->MODEL->MASS PROPERTIES and I can temporarily see the CG. I just cannot seem to figure out how to save it so that I can see it as I drag a sub-assembly using a pinned connection. I just want to observe the location of the CG as I move the sub-assembly.

(Wildfire 4.0, M070)

Sincerely,
Neal Rosenblum
Geometrix Engineering, Inc.
201 N. 13th Avenue
Hollywood, FL 33019
Ph:954-920-2049
Fax: 954-920-9574
Cell:954-649-9399
<u>neal@geometrixeng.c</u>

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[tyler.smith]

In WF3, make sure you switch the dropdown from 'Quick' to 'Feature'.
Then, on the Feature tab, you can choose to have the analysis feature
create a coordinate system at the CG for you. Hope this helps.

Tyler

[dgschaefer]

If you don't want a feature, but just want it displayed so you can spin,
click the glasses icon instead of the checkmark. Silly icon choices,
why would the check mark do the analysis and then immediately exit the
dialog? What good is having the results displayed for a nanosecond?

BTW - The blue arrows button resets the dialog box so you can make new
choices

Doug Schaefer