cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Translate the entire conversation x

How to get UN and UNEF threads in "standard thread type" pull-down menu in Hole command

bmohapatra
10-Marble
10-Marble
‎Dec 04, 2015 05:13 AM
‎Dec 04, 2015 05:13 AM

How to get UN and UNEF threads in "standard thread type" pull-down menu in Hole command

Can anybody know how to get other standard like UN & UNEF threaded Hole as shown below ?

 

Untitled.png


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
0 Kudos
Notify Moderator
1 REPLY 1
RonSt.Pierre
12-Amethyst
12-Amethyst
(To:bmohapatra)
‎Dec 04, 2015 05:55 AM
‎Dec 04, 2015 05:55 AM

create or get from a source the desired hole file, place the file in the folder with the existing .hol files

check out this thread (no pun intended)

Re: CALLOUT_FORMAT in *.hol files

0 Kudos
Notify Moderator
Announcements
NEW Creo+ Topics: Real-time Collaboration

Contact Community Management
Top Tags