How to perform a simple swarf milling

[JavierGarcia]

I have little experience with multiaxis machining and I am struggling with a simple swarf milling. The surface i want to mill is the following:

I have tried several sequences. With swarf milling sequence the tool does not seem to follow the surface:

I can´t make trajectory sequence work...

I have done in the past some nice toolpaths with cut line milling but in this case i can´t get gouge free paths... 

Any help would be greatly appreciated..

Some cross sections of the part:

  

[mejde]

Hi, you wish to machine this surface only with the side of the tool?

[JavierGarcia]

Yes, only the side

[gkoch · Accepted solution]

Are you sure the surface can be machined with the tool side?

There are some concave looking areas - is there always a straight or convex path through each point on the surface, so that it can be machined?

[JavierGarcia]

I think so. PTC is looking into it and the case has been reported to R&D...

[JavierGarcia]

It can´t be machined the way i wanted.... it is not geometrically possible.