Importing .sat files in v19

[lbenjamin]

Can someone tell me what happened to the ability to load/save .sat files in Creo Elements Direct Modeling. I went to load a .sat file today and did not even find it as an option - it was there in v18... Did I miss a check box in the install??

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[Mahesh_Sharma]

Lynda,

This post is realted to Creo Elements/Direct, moving the post to Creo Elements/Direct

[lbenjamin]

Never mind... I found that I had not checked all the interfaces I wanted (like .sat, .stl, SolidWorks, etc) under the 'Data Interfaces' section of the 'Startup...' section of the Modules setup.