cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Translate the entire conversation x

Increase ModelCheck "overall_size" Decimal Places

Go to solution
GE_5841333
4-Participant
4-Participant
‎Jan 20, 2022 08:00 AM
‎Jan 20, 2022 08:00 AM

Increase ModelCheck "overall_size" Decimal Places

I am using Creo Parametric - Release 7.0 (connected) 7.0 7.0.5.0

We've enabled the "overall_size" parameter in ModelCheck, but it keeps placing 2 decimal place values for the parameter. We'd like to have three decimal place values generated for that parameter, but we haven't been able to make it work. Please advise.

Labels:
0 Kudos
Notify Moderator
ACCEPTED SOLUTION

Accepted Solutions
VladimirN
24-Ruby III
24-Ruby III
(To:GE_5841333)
‎Jan 20, 2022 08:56 AM
‎Jan 20, 2022 08:56 AM

Article - "Is it possible to reduce the decimal places in value for OVERALL_SIZE generated by ModelCHECK in Creo Parametric": https://www.ptc.com/en/support/article/CS227020  

View solution in original post

Notify Moderator
1 REPLY 1
VladimirN
24-Ruby III
24-Ruby III
(To:GE_5841333)
‎Jan 20, 2022 08:56 AM
‎Jan 20, 2022 08:56 AM

Article - "Is it possible to reduce the decimal places in value for OVERALL_SIZE generated by ModelCHECK in Creo Parametric": https://www.ptc.com/en/support/article/CS227020  

Notify Moderator
Announcements
NEW Creo+ Topics: Real-time Collaboration

Contact Community Management
Top Tags