All:
Does anyone know why 'Layer Properties' is sometimes grayed out on a
component whose Workspace status is 'Clear', Commonspace status is
'Unlocked', and Release Level is 'Initial'? I run across this problem quite
often; usually I can restart Pro and reopen the component and it's
available, but this has not been the case with the assembly I'm currently
working on. Nothing in the workspace is locked, read-only or released.
I'm on WF 2.0, M280, with Pro/INTRALINK 3.4, M050.
Thanks in advance for any help offered.
Regards,
Carol Fly
efefefefefefef
Applied Research Labs
University of Texas at Austin
Carol Fly
Mechanical Designer
(512) 835-3397
Fax (512) 835-3259
efefefefefefef
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
