MBD Weld position & Arrow jogs

[Matthijs1]

Using Creo Parametric 10.0.4.0

I'm drawing a welding assembly and I've got welds that have arrows going through parts of the assembly.

I would like to add jogs to the arrows so I can route them around the part instead. Is there any way to do this?

And is there a way to move the weld symbol to another plane whilst keeping the arrows as they are. Right now, when I move the weld symbol to another plane, all the arrows move to that same plane and are no longer connected to the actual welds.

Hope you can help me out! 🙂

[vnamboodheri]

Hi @Matthijs1,

Thank you for your question. 

Your post appears well documented but has not yet received any response. I am replying to raise awareness. Hopefully, another community member will be able to help.

Also, feel free to add any additional information you think might be relevant. 

Regards,

Vivek N
Community Moderation Team.

[StephenV]

I'm not the iniator of this thread, but I had answered to it and so did many, many others. Please relook at it and acknowledge that I, Stephen Virgilio had sent this thread up to likes of you in the Moderation Team and/or Committee so that the issue of this in all Creo releases (up to 12) has not seen any changes and wishes are for some type of reasoning why can't this be implemented in Creo, but best answer would be, 'Yes we at PTC could provide for this issue by adding it into a new release or version of Creo##.'

Thank you!

Stephen

[StephenW]

@StephenV 

If you would like to make an enhancement request for Creo, please create a post in the idea area of the forum. This is the "official" process PTC has designate for enhancement requests.  Community moderators will sometimes move a post from this board when "accidentally" posted in the wrong location, but this specific post was a question of how or if a jog could be made, not an enhancement request.

https://community.ptc.com/t5/Creo-Parametric-Ideas/idb-p/creoparametric