cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can subscribe to a forum, label or individual post and receive email notifications when someone posts a new topic or reply. Learn more! X

Make arc snap over the hole?

AS_11004841
4-Participant

Make arc snap over the hole?

I'm trying to turn this hole into a slot. I tried placing a palette over the hole but it doesnt snap. Is there a way to make it snap over perfectly? or do I have to line them up manually? Using Creo 10.

AS_11004841_0-1713772806356.png

 

1 ACCEPTED SOLUTION

Accepted Solutions

If your design intent is to use the hole to locate something in a sketch, then make sure to include the edges/center of the hole as a reference in the sketch where you are creating the slot.

========================================
Involute Development, LLC
Consulting Engineers
Specialists in Creo Parametric

View solution in original post

1 REPLY 1

If your design intent is to use the hole to locate something in a sketch, then make sure to include the edges/center of the hole as a reference in the sketch where you are creating the slot.

========================================
Involute Development, LLC
Consulting Engineers
Specialists in Creo Parametric
Top Tags