ModelCheck control Sheetmetal Bend Allowance

[ablazy]

Hello,

Would it be possible to request an enhancement to ModelCheck?
Specifically, I would like ModelCheck to be able to verify the Bend Allowance settings. For example, I would like to check that for sheetmetal parts, the “Bend allowance driven by” option is correctly set to be driven by the material.
Even further, I would like to validate that the Sheetmetal Preferences are consistent with the smtdsnsetup.smd configuration file.

Thank you in advance if this request could be considered.

Adrien Blazy

[VladimirN · Accepted solution]

You can submit your idea here.- "Creo Parametric Ideas":
https://community.ptc.com/t5/Creo-Parametric-Ideas/idb-p/creoparametric 
https://community.ptc.com/t5/forums/postpage/board-id/creoparametric/search-before-post-mode/true