Modify Spline Drag Handles

[dgschaefer]

WF5 M090



In prior versions, if a spline had one end constrained with an angle
dimension or tangent constraint but the other was not, you could not
modify the drag handles. However, if both were constrained or both were
free you could. In WF5, it seems that you cannot modify them unless
both are free. This is a serious limitation and a rather large step
backwards.



Am I missing something here?



Doug Schaefer

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[BobSchwerdlin]

Doug,

In sketcher mode, I can modify a spline using drag handles without any problem. As an example - two curve entities with a spline created in-between and made tangent on each end. I get drag handles when I choose Modify.

Bob Schwerdlin
Design Engineer,
Dukane Corp.
2900 Dukane Dr.
St. Charles, IL 60174
630-797-4974 direct
-