Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
There are a bunch of OOTB check and update options available in ModelCHECK. However, they are not enough to address various demands. Here are the ones I collect so far. Are there any ones are required but they are not in the list?
Checks:
verify DTL used in 3D model
assembly accuracy
GEOMETRIC_TOL for drawing
warning and error option for ASM_FEATURES
check component parameters
check system parameter as any user define parameter
give an error message when a model is not completely regenerated
enable to check "All Levels" of an assembly when ran in "Save Mode“
REGEN_DIMS works in interactive mode
layer state in combined view
lightweight holes
there have been dimensional changes but that the part has not been regenerated
indicates that ModelCHECK was run on a simplified rep and not the master rep
part density(minimum/maximum acceptable range)
indicates that material density has been changed from the material card value
Huge volume caused by coordinate systems being offset at a tremendous distance
Updates:
assign material to part with Batch Mode
remove all Parameters at once
create a Parameter which contains the OVERALL SIZE value ONLY from the SOLID Geometry
Assembly cuts outside of the model - This has caused us a lot of performance issues and would be nice to warn or block these from happening. The automatic inclusion of components sometimes gets to be huge with complex assemblies.
