cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Open Creo 2 part or assembly with WF4?

borr
1-Newbie

Open Creo 2 part or assembly with WF4?

Is there a way to save a part or assembly (and maintain parameters) in Creo 2 that wildfire 4 can open and use/edit the full geometry or assembly?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions
TomD.inPDX
17-Peridot
(To:borr)

Not really. There is an application called Granite (from PTC) that is suppose to be for this but it is not a one-for-one open... it is more of an import converter.

View solution in original post

2 REPLIES 2
TomD.inPDX
17-Peridot
(To:borr)

Not really. There is an application called Granite (from PTC) that is suppose to be for this but it is not a one-for-one open... it is more of an import converter.

JamesBurcham
4-Participant
(To:borr)

This is a common questions. Look at this conversation it should answer your question.

http://communities.ptc.com/thread/36253

Top Tags