Ladies and gents,
We're running Creo 2.0 Parametric build M030. When one of our users was creating a parametric note for a radial dimension, attaching it to another view, the orientation of the radius callout "R" moved in the dimension - instead of being at the beginning it moved into the center.
We use dual dimensioning and limit tolerancing. I've tried a number of things and found this - in the drawing properties, if I change settings as follows we get these results:
1) Here's where we started
[cid:image016.jpg@01CE71B2.EA0C6000][cid:image017.jpg@01CE71B2.EA0C6000]
And we get these results
[cid:image018.jpg@01CE71B2.EA0C6000][cid:image019.jpg@01CE71B2.EA0C6000]
And finally, if we turn off "LIMITS" Tolerance Mode we get the radial "R" callout back where it belongs
[cid:image020.jpg@01CE71B2.EA0C6000]
The same thing happens with diameter dimensions. Has anyone run into this? Config settings, ........ ????????? Bug???????
Looking for any assistance I can get - thanks in advance!
Regards,
Mike Brattoli
Moen Incorporated
Global Strategic Development
Engineering Systems Administrator
25300 Al Moen Drive
North Olmsted, OH 44070
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
