I know this has been covered many times, but I wanted to see if there was anything new.
I have a frame assy consisting of 8 pieces of aluminum extrusion. These are miter cut and butt jointed together and welded. The heat from the weld operation (continuous fillet at each joint) means that the frame shrinks in size, so I've specified the frame size and the piece size to accommodate based on our fabricators experience. What that means is that there is 0.05mm of interference at each joint in Pro/E. Not really a big deal, except that the edge where I need to attach one of my weld symbols is missing.
In the past, the solution to this was to eliminate the interference, but I really can't change my part lengths and I don't want to create a whole other set of parts just to make this drawing work.
Any new tricks here?
Doug Schaefer
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
