cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Pic_1.pdf

kmaltzahn
1-Newbie

Pic_1.pdf

Hello   I need to create the  auger that i have attached.  I can do the spiral and the straight piece going down the center of the spiral. But connecting the two is a problem If anyone can that would bee great   I am on CREO 2.0


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1

Create a discussion instead of document and upload your model.


Martin Hanák
Top Tags