Pro Man, W5 M60

[ptc-21369]

I am posting a program to a machine tool that does not except moves less than .0002. Is there a way that I can control the data output without sacrificing the quality of a majority of the finishcuts? Is it possible to do this in the parameters?

Ronald Swift

Engineering Supervisor

Zirc Company

3918 Highway 55 SE.

Buffalo, MN. 55313

rons@zirc.com

P: 800-328-3899 | 763-682-6636 | F: 763-682-6604

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[DanielSantos]

Hi Ronald,



You can set the linear resolution in GPOST to be 0.0002” – However, that won’t guarantee your finish cuts will be as good as it could be (Or as good the Pro/NC computed it to be) as the post will skip moves that do not fall within that resolution.







Cheers

Daniel



From: Ronald Swift [