Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X
I am posting a program to a machine tool that does not except moves less than .0002. Is there a way that I can control the data output without sacrificing the quality of a majority of the finishcuts? Is it possible to do this in the parameters?
Ronald Swift
Engineering Supervisor
Zirc Company
3918 Highway 55 SE.
Buffalo, MN. 55313
rons@zirc.com
P: 800-328-3899 | 763-682-6636 | F: 763-682-6604