cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Reduction of empty subassemblies when importing a STEP neutral format

HQ_10568951
4-Participant

Reduction of empty subassemblies when importing a STEP neutral format

Hello PTC community,

I have the following problems: 

I want to import data via STEP. The import does not cause me any problems, only after the import there are always too many sub-assemblies that I do not want to have. Is there any way in Creo to eliminate these "intermediate assemblies" (See pictures).  Are there any special import profiles?

 

HQ_10568951_1-1675076217527.png        HQ_10568951_2-1675076287448.png

 

I would appreciate any suggestions and tips.

 

Many thanks in advance. 

 

 

 

 

 

 

ACCEPTED SOLUTION

Accepted Solutions

Hi,

you cannot eliminate these "intermediate assemblies".


Martin Hanák

View solution in original post

3 REPLIES 3

Hi,

you cannot eliminate these "intermediate assemblies".


Martin Hanák

Hi Martin,

Thank you for your support. I still have one question, where can I find the detail descriptions for the different import profiles. 

 

Many thanks in advance.

 

 


@HQ_10568951 wrote:

Hi Martin,

Thank you for your support. I still have one question, where can I find the detail descriptions for the different import profiles. 

 

Many thanks in advance.

 

 


Hi,

I am sorry I do not understand your question.


Martin Hanák
Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags