Reduction of empty subassemblies when importing a STEP neutral format

[HQ_10568951]

Hello PTC community,

I have the following problems: 

I want to import data via STEP. The import does not cause me any problems, only after the import there are always too many sub-assemblies that I do not want to have. Is there any way in Creo to eliminate these "intermediate assemblies" (See pictures).  Are there any special import profiles?

        

I would appreciate any suggestions and tips.

Many thanks in advance. 

[MartinHanak · Accepted solution]

Hi,

you cannot eliminate these "intermediate assemblies".

[HQ_10568951]

Hi Martin,

Thank you for your support. I still have one question, where can I find the detail descriptions for the different import profiles. 

Many thanks in advance.

[MartinHanak]

---

@HQ_10568951 wrote:

Hi Martin,

Thank you for your support. I still have one question, where can I find the detail descriptions for the different import profiles. 

Many thanks in advance.

---

Hi,

I am sorry I do not understand your question.