Community Tip - You can Bookmark boards, posts or articles that you'd like to access again easily! X
I would like to see the restricted parameters file allow entries for SMT_THICKNESS so default material thickness values can be grabbed easily when defining the sheetmetal thickness.
Hi Antonius -
Looks like your response cannot be viewed by the community - is everything good on your end?
Would you please repost?
Thank you,
Toby
I have no idea as to what the link was. 1st time that appened in the forum that I know of.
Hmmm - did you try to post a link?
Sometimes that puts the post into a moderation queue.
Thank you,
Toby
Probably an ideas link. I simply don't recall my reply.