Rounding Off dimension tolerance again shown as same earlier?

[mgupta-4]

Dear All,

while working on the drawing , the dimensions it shows like 4 precision ,i changed it upto 2 places .

But after closing and open it again ,all the dimension tolerance shown as before .

Please help.

Manish

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[TomD.inPDX]

Can you post an image of the property change you are making to make the change?

[mgupta-4]

please see the image as i again make it round by properties ,it appear again.

Manish

[TomD.inPDX]

That is dual dimensions rather than tolerance.

This is normally set in the detail.dtl settings (drawing settings file).

It is a global setting.

See dual_digits_diff