cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about the Community Ranking System, a fun gamification element of the PTC Community. X

Rounding Swept Blend Transition

ptc-267878
1-Newbie

Rounding Swept Blend Transition

wildfire 3.0 m160


Having trouble adding a round (GREEN LINES) between 2 swept blends connected together (RED ARROWS) as seen in the attached figure. the swept blend on the right is a curved cylinder, and the swept blend on the right is made from irregular splines along the same curve. any suggestiosn?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
2 REPLIES 2

Looks like the round goes from concave to convex via. the top view.

Project curves on the surfaces of each side to create two boundaries for a boundary blend instead of a round....see if that works.

Top Tags