Route cables>Follow Cable HELP

[abesau]

I can't figure out how to follow cable in Creo 2.0.  It used to be so simple in WF4!!! 

Can anyone shed some light?  Options are Cable to follow: <pick wire>

From: <what does the system expect?> To: <What does the system expect?>

I pick a location from and a location to but yet it does not work.

I can successfully route it manually picking each location point, but it will just not follow it!!!

Any videos out there??

Thanks

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[gkoch]

In Creo the From and to should always be defined first (e.g. by logical data or by manually selecting) - only then different methods to route are available.

You can add locations or use other means, like selecting to follow network / other cables.