Sheet Metal Bend Tables

[mirzanasrullah]

Hello All,

Can anyone be able to explain me about the bend tables in Creo2/ProE.

If need to edit the tables as pe rmy requirement of Galvanised Steel 2mm, 3mm & 4mm

Thnaks.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[ClintWalton]

Hi Mirza,

I just responded in the other thread not realizing you had already creating a separate discussion.

Here is some helpful documentation:

• Bend Allow Directory: https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS95686&source=tssearch

• Vary Factor with Bend Table: https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS116355&source=tssearch

• Help Center - Bend Allow and Dev Len: http://www.ptc.com/cs/help/creo_hc/creo20_hc/pma/sheetmetaldesign/Set_Up/About_Bend_Allowance_and_Developed_Length.html?queryId=1481ce1d75c

• Help Center - Setup of Bend Table: http://www.ptc.com/cs/help/creo_hc/creo20_hc/index.jspx?id=Set_Up-About_Bend_Tables&action=show

• Help Center - About K/Y Factors: http://www.ptc.com/cs/help/creo_hc/creo20_hc/index.jspx?id=Set_Up-About_Y_factor_and_K_factor&action=show