Skip to main content
K
kkamani1-Visitor
1-Visitor
January 12, 2015
Question

Creo Hanged while Creating new dimension or moving a drawing view

  • January 12, 2015
  • 1 reply
  • 1043 views

Dear all,

I am facing this problem from long time..

I have Drawing with some Imported Drafting lines from .dwg .

I this drawing when i place a new dimension or move a Exiting drawing view then creo will hang for 2 mins.

in status bar i found a message like " Entities do not form loops; cannot modify draft xhatching ".

I am using Creo parametric 2.0 M120.

Regards,

Kishan


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

C
ClintWalton1-Visitor
1-Visitor
February 5, 2015

Hi Krishan,

I just did a quick search on this. I found old case where a customer was having the same issue with a .dwg and the following document resolved the problem.

https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS108951

Terms & ConditionsAccessibility statement