Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email.
X
I remember the days when you tell it what to shell.
I think since WF it shells the whole part and you subtract (remove surfaces)
If I extrude, then shell, then add another extrude, then shell...it picks the whole part.
I try to mess with it to no avail.
hopefully I am clear on this.
Anyone?
Nothing critical. Just looking into pet peeves between assignments.
WayneF This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
But, you could create the subsequent features as closed/capped surfaces, offset it, solidify the parent then use the offset to solidifly as a cut. You can do that all day long.
I have yet to post a summary on this. So far - a few responses like yours with the exception of the offset and solidify options, which I have used. This may be too much.
I guess it it be nice to shell more than once. This would be quicker than a offset edge chain option.
There are reasons why it would not work well....in considering molding, etc.
