Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
Can we release one rotational degree of freedom in contact analysis in creo simulate. When i tried giving a specified rotation to a cylindrical part but got a warning saying "you constrained rotational DOF for an entity that does not have rotational DOF". How shall we give a specified rotation to a part and do contact analysis on it? Can anyone throw some light on this. Thanks is advance for the replies
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Could you tell me the procedure in which we can do this. Coz I come across warning saying "The geometrical references may be in conflict with another constraint or dependent side of rigid/weighted link."
A warning is just a warning, not an error - this quite often occurs. Just review your results carefully to make sure that the model is behaving as you expect (which you should always do, anyway!).
