cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Subscript and superscript for relations in annotations and dimensions

rjensen-2
Newbie

Subscript and superscript for relations in annotations and dimensions

Hello

Is it possible to display a relation value as subscript and superscript (displayed as a tolerance) on the drawing?

I have two values i want displayed as a tolerance.

Inserting the relation in the annotation:

&+D_HOLE_TP

&-D_HOLE_TM

My values show up:

27-08-2015 16-04-21.jpg

Result is good.

But using this command to display the values in subscript and superscript: TEXT@++VALUE1@#@--VALUE2 - it does not work.

Without relations, the result is good:

27-08-2015 15-59-31.jpg

Inserting my relations like this: TEXT@++&D_HOLE_TP@#@--&D_HOLE_TM the result is not good:

27-08-2015 16-04-07.jpg

Best Regards.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Tags (2)
Announcements