Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X
Hello
Is it possible to display a relation value as subscript and superscript (displayed as a tolerance) on the drawing?
I have two values i want displayed as a tolerance.
Inserting the relation in the annotation:
&+D_HOLE_TP
&-D_HOLE_TM
My values show up:
Result is good.
But using this command to display the values in subscript and superscript: TEXT@++VALUE1@#@--VALUE2 - it does not work.
Without relations, the result is good:
Inserting my relations like this: TEXT@++&D_HOLE_TP@#@--&D_HOLE_TM the result is not good:
Best Regards.