Thanks to Dan Harlan, who also turned me onto the Reference Viewer, and many
others who suggested basically the same thing: I backed up my assembly to a
folder on my hard drive, checked out the existing assembly and all of its
components from Windchill Cabinets, and Imported my version of the assembly
from my hard drive, with imported objects shown as modified, and only
Required dependent objects. This resolved my conflicts and gave us a clean
assembly in the Windchill Cabinets.
efefefefefefef
Applied Research Labs
University of Texas at Austin
Carol Fly
Mechanical Designer
(512) 835-3397
Fax (512) 835-3259
efefefefefefef
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
