Hi,
I have an assembly and there is very much component in it. I took a snapshot and exploded this snapshot in order to show it on drawing. I complated all of these steps. Everything is allright so far.
But,
I needed to add a component to my assembly. And i updated snapshot because of this new component. Then i wanted to edit exploded view but when i clicked on "Edit Position", the view did not explode. Everything was gone. And drawing was mixed up as well.
It was very complicated exloded view. I don't want to try to make it again.
So how can i bring it back?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
