Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily.
X
i'm trying to rough using volume, but the tool is invading (within green square in picture attached) the only way i know is to change the model but i don't want to do that because i will have a few problems, i would like to know if anybody knows another way for the nc sequence recognize a surface or anything else as part.
Hi bambi! Try to add the fixture surfaces as check surfaces...or use a mill window to limit the tool so that it won't cross the boundaries you set... Kct de agulha! Daniel
